Wire and tube quoting that counts the bends
You have had the call where the wire forms come back unrecognised and the quote never happens. Customiser measures the geometry.
Where time is lost
Four problems that slow every quote.
Bends counted by hand.
Every form and radius, off a printed drawing.
Platforms that cannot read your parts.
Flat pattern engines fail on centrelines, so your most important parts come back empty.
Mixed assemblies.
Wire, tube, plate, hardware and finishing in one part, priced in four places.
Two lanes, one deadline.
Domestic and import paths need different maths and both are due at once.
What Customiser reads
Five capabilities, one pass.
Bend counts from geometry.
Centrelines decomposed into straights and arcs.
Radii and cut lengths.
Every bend carries its radius, every run its length.
Hole schedules.
Diameters, counts and wall counts on flat and tube components.
Hardware detection.
Fasteners, weld nuts, rivets and bought in parts counted.
One pass, whole assembly.
Formed parts, plate, tube and hardware in one BOM.
STEP · IGES · CENTRELINE EXTRACTION · BEND COUNT · BEND RADII · CUT LENGTH · HOLE SCHEDULES
Wire and tube fabrication FAQ
Send us the part they could not read
One assembly, one call. If we cannot read it you will know in thirty minutes.
customiser